Modbus TCP with Saia PCD3

Discussion about communication protocols (configuration, functions, hardware required).
Post Reply
manutenzioneinfra
Posts: 19
Joined: Tue May 17, 2011 11:02 am

Modbus TCP with Saia PCD3

Post by manutenzioneinfra »

Hi i use this kind of communication to read/write register and "only read" coil with my plc Saia PCD3 configured as server in modbus tcp. I wrote "only read" because if i try to write a coil i have this kind of issue..the communication on winlog goes in error, not into the plc, and the strange thing is that the coil is written. Do you have some idea to solve the problem?

Thanks
User avatar
admin
Site Admin
Posts: 373
Joined: Tue Nov 17, 2009 1:18 pm

Re: Modbus TCP with Saia PCD3

Post by admin »

Hi,
which Winlog version are you using? In gate configuration you have set "Enable Writing to device"?

Best regards
manutenzioneinfra
Posts: 19
Joined: Tue May 17, 2011 11:02 am

Re: Modbus TCP with Saia PCD3

Post by manutenzioneinfra »

Hi,
winlog Version 2.07.30, writing to device enabled.example Writing command 1:
I have used this kind of protocol with telemecanique plc without problems, the strange thing is that the protocol fall down after the correct writing command of the coil variable.
User avatar
admin
Site Admin
Posts: 373
Joined: Tue Nov 17, 2009 1:18 pm

Re: Modbus TCP with Saia PCD3

Post by admin »

Hi,
I think that the PLC does not respond correctly to coil writing. Numeric gate are writing correctly?
manutenzioneinfra
Posts: 19
Joined: Tue May 17, 2011 11:02 am

Re: Modbus TCP with Saia PCD3

Post by manutenzioneinfra »

Hi, yes numeric gates are correctly written.
Post Reply