RS 232 Problem

Discussion about communication protocols (configuration, functions, hardware required).
legolas21
Posts: 2
Joined: Fri Jun 14, 2013 6:53 am

RS 232 Problem

Postby legolas21 » Fri Jun 14, 2013 7:14 am

hello,

i have a built-up device that continuously sending data through serial 232.
my device sending float type data with 1sec interval.


on winlog i use ascii raw output protocol. setting :string gate, never sample, write enabled.
the connection in winlog is ok.

i try with hyperterminal, the data is received and good condition.
but with winlog i use the label %S and set the gate, but the label didn't change..

any advice?
thanks...

User avatar
admin
Site Admin
Posts: 322
Joined: Tue Nov 17, 2009 1:18 pm

Re: RS 232 Problem

Postby admin » Thu Jun 27, 2013 8:19 am

Dear Sir,
Serial Raw Ascii ouput protocol is only for send command on serial port, not for reading ascii string.

Best Regards

legolas21
Posts: 2
Joined: Fri Jun 14, 2013 6:53 am

Re: RS 232 Problem

Postby legolas21 » Fri Jun 28, 2013 4:23 am

so for receive data from my device through rs232,

what protocol should i use?

User avatar
admin
Site Admin
Posts: 322
Joined: Tue Nov 17, 2009 1:18 pm

Re: RS 232 Problem

Postby admin » Fri Jun 28, 2013 7:14 am

Dear Sir, at the moment there isn't this communication protocol.

Regards


Return to “Protocols”

Who is online

Users browsing this forum: No registered users and 0 guests