I'm a new user of Scada software, i want to create application with the below details, but i do not know,how?
please help me.
i have 3 devices that use MODbus protocol. these device send data through RS485 port to access point #1, then access point #2 receive data and send data to computer.
scada software is install on this computer. i want to design scada application that show device's parameter on this computer and then send data to RTU.
i have any question about this scada application, for example:
number of channel?
receive data protocol?
send data protocol?
how to break up these 3 device with single channel?
and all thing that help me to design this scada application.
General discussion about Winlog.
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest