Page 1 of 1

Winlog and Weintek Pass-through mode

Posted: Thu Sep 12, 2019 5:37 pm
by vasilevdim
Hello,

I am trying to read with Winlog from PLC OMRON CJ2M via Weintek HMI using pass-through mode, and so far no luck. For sure pass-through mode is properly working, since I can connect to the PLC with CX Progammer. Is Winlog able to work at all with this configuration (mean PC with Winlog installed-Ethernet connection to HMI Weintek -pass-through mode- serial connection to Omron PLC CJ2M?

Thank you,

Best regards,

D.Vasilev