modbus tcp/ip

[pangya]

is the winlog support connection modbus tcp to modbus RTU ?

i bought a converter modbus RTU to modbus TCP,
tried configure the protocol modbus TCP in winlog but there is no option to pick id for modbus RTU.

is the host name or ip addres can replace by modbus RTU device id ?

[admin]

Dear Sir,
Device id is set in gate builder, on "device". If you use a gateway you must associate the gateway IP address with DeviceId in Protocol configuration.

modbus_tcp_gate.png (19.25 KiB) Viewed 2661 times

modbus_tcp.png (23.42 KiB) Viewed 2661 times

(See the modbuss help for more information)

[pangya]

thx for ur explanation.

but what explanation that i need:
in modbus TCP protocol configuration ,can the ip address device replace with device id in modbus RTU ?

the scheme is like this : modbus TCP -> modbus RTU

modbus TCP is only as a gateway to communicate in modbus RTU

[admin]

Hi,
Winlog send frames in modbus TCP and modbus RTU over TCP. Your gateway converts them into Modbus RTU.
The device id that sends Winlog is what you insert in Gate Builder.
Putting the Device ID instead of IP address is a nonsense!

Regards

[pangya]

i using ss3580 gateway.

its should transfer from modbus TCP to RTU right ?

but how can i choose the RTU device when the option onyl to target ip address ?

BR

[admin]

Dear Sir,

its should transfer from modbus TCP to RTU right ?

Yes

but how can i choose the RTU device when the option onyl to target ip address ?

When you insert "Device" number in gate configuration, this is the Modbus device address. Please read the help of Modbus RTU and Modbus TCP, all these questions have already been answered.

Best Regards