Page 1 of 1

Connect IC912 and IC915 Eliwell devices

Posted: Wed Nov 27, 2013 12:11 pm
by onsitemadrid
Hi.

I'm trying to connect this devices to Winlog Pro. I have the OCX. The manufacturer says that this devices can work with MODBUS protocol. The problem is that addressing of these devices is defined by family (from 00 to 14) and device (from 00 to 14). I was unable to locate the manuals or any web that explain how to implement this devices in MODBUS.

Does anyone know how to do it?

Thanks in advance.

Enrique

Re: Connect IC912 and IC915 Eliwell devices

Posted: Wed Nov 27, 2013 2:18 pm
by admin
Dear Sir,
I think it is appropriate to contact the customer support of Eliwell. They must provide the Modbus address table of your device.
Without the correct Modbus addresses is very difficult to communicate with instruments.

Best Regards