Telemecanique TSX ethernet connection by XWAY driver

Discussion about communication protocols (configuration, functions, hardware required).
Post Reply
manutenzioneinfra
Posts: 19
Joined: Tue May 17, 2011 11:02 am

Telemecanique TSX ethernet connection by XWAY driver

Post by manutenzioneinfra »

Hi, i have this question..on a PC i have my XWAY driver installed, with my XIP configuration for ethernet connection with Telemecanique TSX that is working good. I have decide to change the actual scada (Monitor Pro by Schneider) and i want to use Winlog. I don't want to change nothing on the PLC, so i need to know if it's possible to work with this kind of driver with winlog.
Thanks
Lorenzo
User avatar
admin
Site Admin
Posts: 373
Joined: Tue Nov 17, 2009 1:18 pm

Re: Telemecanique TSX ethernet connection by XWAY driver

Post by admin »

Dear Sir,
XWAY is a proprietary protocol not supported by Winlog.But normally plc also support the Modbus TCP protocol, check if your plc is compatible with the modbuss RTU TCP.

Best Regards
manutenzioneinfra
Posts: 19
Joined: Tue May 17, 2011 11:02 am

Re: Telemecanique TSX ethernet connection by XWAY driver

Post by manutenzioneinfra »

Thank you so much, Modbus RTU TCP is working good!!! Very simple and fast to setup.

Thank
Post Reply