Page 1 of 1

RS 232 Problem

Posted: Fri Jun 14, 2013 7:14 am
by legolas21
hello,

i have a built-up device that continuously sending data through serial 232.
my device sending float type data with 1sec interval.


on winlog i use ascii raw output protocol. setting :string gate, never sample, write enabled.
the connection in winlog is ok.

i try with hyperterminal, the data is received and good condition.
but with winlog i use the label %S and set the gate, but the label didn't change..

any advice?
thanks...

Re: RS 232 Problem

Posted: Thu Jun 27, 2013 8:19 am
by admin
Dear Sir,
Serial Raw Ascii ouput protocol is only for send command on serial port, not for reading ascii string.

Best Regards

Re: RS 232 Problem

Posted: Fri Jun 28, 2013 4:23 am
by legolas21
so for receive data from my device through rs232,

what protocol should i use?

Re: RS 232 Problem

Posted: Fri Jun 28, 2013 7:14 am
by admin
Dear Sir, at the moment there isn't this communication protocol.

Regards