I am trying to read with Winlog from PLC OMRON CJ2M via Weintek HMI using pass-through mode, and so far no luck. For sure pass-through mode is properly working, since I can connect to the PLC with CX Progammer. Is Winlog able to work at all with this configuration (mean PC with Winlog installed-Ethernet connection to HMI Weintek -pass-through mode- serial connection to Omron PLC CJ2M?
Discussion about communication protocols (configuration, functions, hardware required).
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest