Page 1 of 1

Program with 1k+ gates

Posted: Wed Mar 27, 2013 2:02 pm
by Martynas1
Is there exist ability on winlog to specify what part of gates to read on particular template? The entire project have more thant 1.2 thousand gates.

Re: Program with 1k+ gates

Posted: Thu May 23, 2013 8:48 am
by admin
Dear Sir,
if you defined port not "Always" sampled, but only "In Monitor", gates are read only when needed. When you open the template that contains 100 gates, only this 100 gates will be read from device.

Best Regards