When I create a report using the code command ReportSetPeriodTime("Flow Rate",0,2,0,0,0,0); the trend image is almost blank as if it is just being created when the report is being formatted. I open the form containing the trend at the same time I run the code above. The trend shows 2 minutes worth of data on the screen but virtually nothing on the report.
Can anyone explain why this is?
I have attached a photo of the trend image from the report.
Discussion about reports creation (CSV,RTF,DOC,PDF etc.).
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest